All Cutting Units Operate Slowly
Cause
__________________________________________________________________________________________
Low engine RPM.
________________________________________________________________________________________________________________________________________________________
Hydraulic oil level too low.
________________________________________________________________________________________________________________________________________________________
Bedknife to reel contact too tight.
________________________________________________________________________________________________________________________________________________________
Reel speed control linkage damaged or out of
adjustment.
________________________________________________________________________________________________________________________________________________________
Charge pressure low in with machine moving and
cutting units engaged - TEST NO. 8.
NOTE: Traction circuit will also be affected.
________________________________________________________________________________________________________________________________________________________
Mowing circuit pressure too low - TEST NO. 3.
________________________________________________________________________________________________________________________________________________________
Mowing circuit flow too low - TEST NO. 4.
Troubleshooting
Correction
Adjust engine rpm - use tachometer.
Fill to proper level.
Adjust bedknife to reel contact.
Repair or adjust control linkage as necessary.
Inspect charge relief valve and adjust or repair if nec
essary.
Inspect auxiliary pump and repair or replace if neces
sary NOTE: Steering and lift will also be affected if
auxiliary pump is damaged.
Inspect mowing circuit pump check/relief valves and
repair or replace if necessary.
Check for damaged pump and repair or replace if
necessary.
Check for damaged pump and repair or replace if
necessary.
Page 4 - 18
®
Reelmaster
335-D