Front Roller Removal And Installation - Toro Greensmaster 3250-D 04383 Service Manual

Front Roller Removal and Installation

Removal
1. Position machine on a clean and level surface, low-
er cutting units, stop engine, engage parking brake, and
remove key from the ignition switch.
Note: The front roller can be removed with the cutting
unit either attached to the lift arm or removed from the
lift arm. Determine your maintenance needs.
2. If removing the cutting unit, remove reel motor from
the cutting unit and the cutting unit from lift arm (see Cut-
ting Unit Removal and Installation). Place cutting unit on
a level working surface.
3. Remove cap screws securing the roller shafts to
each front bracket (Fig. 43).
Note: The right front bracket is secured to the frame
with an eccentric bolt and carriage screw, while the left
front bracket is secured with a shoulder bolt and car-
riage screw (Fig. 43).
4. On either end of the roller, remove eccentric bolt
(shoulder bolt), carriage screw, and lock nuts securing
the front bracket to the frame (Fig. 43).
5. Remove the front brackets and roller from the cut-
ting unit. Remove the front brackets from the roller shaft
(Fig. 43).
6. If the front roller position is to be changed, the re-
maining front bracket may be removed from the frame
using step 4.
Installation
1. Place cutting unit on a level working surface.
2. Determine desired attitude for cutting unit (see Atti-
tude Adjustment).
3. If both front brackets were removed, position brack-
et as follows (Fig. 43):
A. Insert eccentric bolt (shoulder bolt) through the
top hole on the frame and one of the top holes of the
front bracket so the point on the bracket is at the de-
sired position number on the decal (Fig. 44).
B. Screw lock nut onto the eccentric bolt (shoulder
bolt) to hold front bracket in place.
C. Insert carriage screw through the bottom hole of
the frame and front bracket. Secure screw and ec-
centric bolt (shoulder bolt) with lock nuts.
Greensmaster 3250−D
6
7
1
3
2
1. Cap screw
2. Roller
3. Front bracket
4. Eccentric (shoulder) bolt
4. Place roller shaft into the front bracket. Slide second
front bracket on the other end of roller. Secure bracket
as in step 3. (Fig. 43).
5. Apply Loctite 242 or equivalent to the cap screw
threads. Center roller in the front brackets and secure
into place with the cap screws (Fig. 43).
6. Level front roller to the reel (see Adjust and Level
Front Roller to Reel, also see Adjust Attitude).
Page 7 − 23
SPA and 4−Bolt Cutting Units (Rev. A)
4
5
Figure 43
5. Carriage screw
6. Lock nut
7. Lock nut
Figure 44