Setting The Light; Setting Humidity; Alarm; Door Alarm - Siemens iQ700 KF 86N Series Installation Instructions And Instructions For Use

Alarm

en

Setting the light

You can adjust the brightness levels for the following
types of lighting:
Interior lighting In
■
Exterior lighting E
■
The brightness levels can be adjusted from 1 ... 5:
OF = lighting off
■
1 = minimum lighting
■
5 = maximum lighting
■
The interior light In cannot be switched off.
Note:
Set two brightness levels:
Press settings button.
1.
Press light display.
2.
Press N/M button cool-fresh compartment repea-
3.
tedly until the cool-fresh compartment temperature
display shows the required type of lighting.
Press N/M button freezer compartment repeatedly
4.
until the freezer compartment temperature display
shows the required brightness level.
Press settings button.
5.
The setting is saved.
Set the time for the exterior lighting dU:
Press settings button.
1.
Press light display.
2.
Press N/M button cool-fresh compartment repea-
3.
tedly until the cool-fresh compartment temperature
display shows dU.
Press N/M button freezer compartment repeatedly
4.
until the freezer compartment temperature display
shows the required time.
The time set runs through the freezer compart-
Note:
ment temperature display.
20 seconds = "20 SEC"
■
60 seconds = "1 nI"
■
5 minutes = "5 nI"
■
20 minutes = "20 nI"
■
60 minutes = "60 nI"
■
endless = static "oo"
■
Press settings button.
5.
The setting is saved.

Setting humidity

You can set the humidity in the cool-fresh containers
separately:
Touch any control or open the cool-fresh compart-
1.
ment.
Press low, mid or high button to set the desired
2.
humidity.
Close the cool-fresh compartment.
3.
The humidity is set.
Notes
If the temperature in the cool-fresh compartment is
■
set to below 0 °C (32 °F), the controls are locked
and a low humidity is selected automatically
If the temperature in the cool-fresh compartment is
■
not set equal to 0 °C (32 °F), the hyperFresh
premium display goes out.
40
M Alarm
D oor alarm
A l a r m
Switch the door alarm warning signal on or off:
Press settings button.
1.
Press alarm display.
2.
Cool-fresh compartment temperature display
shows AL.
Press N/M button freezer compartment repeatedly
3.
until the freezer compartment temperature display
shows On or OF.
Press settings button.
4.
The setting is saved.
If the appliance door is open for a long time and the
door alarm warning signal is switched on, the warning
signal switches on and the alarm off button flashes.
Close the door or press alarm off button.
■
The warning signal is switched off and the
alarm off button no longer flashes.

Temperature alarm

If the freezer compartment becomes too warm, the
warning signal switches on and the alarm off button
flashes.
Caution!
Bacteria may develop during the thawing process and
spoil the frozen food
Do not refreeze thawing or thawed food.
Refreeze food only after cooking. Do not store frozen
food for the maximum storage period.
The alarm may be actuated without risk to the fro-
Note:
zen food in the following cases:
The appliance is switching on.
■
Large quantities of fresh food are put in.
■
Appliance was open too long.
■
Display warmest temperature in freezer compartment
and switch off warning signal:
Press alarm off button.
■
The freezer compartment temperature display briefly
indicates the warmest temperature reached in the
freezer compartment.The display then indicates the
set temperature again.
From this time on the warmest temperature is
measured again and saved.
The alarm off button remains lit until the set
Note:
temperature is reached again.