Tips For Saving Energy - Siemens iQ700 KF 86N Series Installation Instructions And Instructions For Use

Installation and connection
en
Aligning the drawers
You can align the cool-fresh compartment and the
freezer compartment vertically:
Open the drawer as far as it will go and remove the
1.
container.
Remove the middle screws on both sides.
2.
– The screws are used for factory setting of the
compartment. Either keep the screws or dispose
of them.
Release the upper screws on both sides.
3.
Lift the drawer and remove the lower screws on both
4.
sides.
Move the drawer vertically to the required position
5.
and insert the lower screws in the available holes.
– The drawer can be adjusted by 1/16" (2 mm) up
and down.
Retighten the upper screws on both sides.
6.
To check the position, close the drawer and correct
7.
if necessary.

Tips for saving energy

If you follow the instructions below, your appliance will use less power.
The arrangement of the features does not affect the energy consumption of the appliance.
Note:
Installing the appliance
Keep the appliance out of direct sunlight.
Install the appliance as far away as possible from heating elements,
cookers and other heat sources:
3 cm to electric or gas cookers
30 cm to oil or solid-fuel cookers
If this is not possible, attach an insulating plate between the ap-
Note:
pliance and heat source.
Select an installation location with a room temperature of approx.
20 °C (68 °F).
Do not cover or block the ventilation openings.
Ventilate the room daily.
32
You can adjust the angle of the cool-fresh compartment
and the freezer compartment:
Open the drawer as far as it will go and remove the
1.
container.
Remove the middle screws on both sides.
2.
– The screws are used for factory setting of the
compartment. Either keep the screws or dispose
of them.
Release the upper and lower screws on both sides.
3.
Move the drawer horizontally by the lower screws to
4.
the required position.
Retighten the screws.
5.
To check the position, close the drawer and correct
6.
if necessary.
The appliance needs to cool less frequently at low ambient temperatu-
res and therefore consumes less power.
The air on the back wall of the appliance does not warm up so inten-
sely. The appliance consumes less power if the warm air can escape.