Noises; Normal Noises; Preventing Noises; Faults - What To Do - Siemens iQ700 KF 86N Series Installation Instructions And Instructions For Use

Noise
en
> Noises
N ormal noises
N o i s e
Droning: A motor is running, e.g. refrigerating unit, fan.
Bubbling, buzzing or gurgling: Refrigerant is flowing
through the tubes.
Clicking: Motor, switches or solenoid valves are
switching on and off.
Cracking: Automatic thawing successful.
3 Faults – what to do?
B efore you call customer service, use this table to check whether you can rectify the fault yourself.
F a u l t s – w h a t t o d o ?
Temperature differs greatly from the set value.
Displays do not illuminate.
The mains plug has not been inserted properly.
The fuse has tripped.
The power has failed.
Display shows E....
Electronics have detected a fault.
The alarm off button flashes and a warning signal sounds.
Refrigerator compartment, cool-fresh compartment or freezer com-
partment is open.
Ventilation openings are covered up.
Large quantities of fresh food were placed in the appliance.
The temperature in the refrigerator compartment, cool-fresh compart-
ment or freezer compartment is too warm.
Appliance is not cooling, display and lighting are lit.
Showroom mode switched on.
--------
48

Preventing noises

Appliance is not level: Align appliance using a spirit
level. If required, place a little packing underneath.
The appliance is not "free-standing": please move the
appliance away from adjacent furniture or appliances.
Containers, shelves or storage compartments wobble
or stick: Check the removable fittings and re-insert if
required.
Bottles or receptacles are touching each other: Move
bottles or receptacles away from each other.
Switch off appliance for 5 minutes.
~ "Switching off and disconnecting the appliance" on page 38
If the temperature is too warm, check temperature again after a cou-
ple of hours.
If the temperature is too cold, check temperature again on the follo-
wing day.
Connect the mains plug.
Check the fuses.
Check whether the power is on.
Call Customer Service.
~ "Customer service" on page 49
Press alarm off button. The alarm is switched off.
Close the appliance.
Clear the ventilation openings.
Do not exceed maximum freezing capacity.
Press alarm off button. After the alarm off button is pressed, the war-
mest temperature reached in the freezer compartment is displayed
for 5 seconds. The display stops flashing.
Start the appliance self-test.
~ "Appliance self-test" on page 49
When the programme has ended, the appliance switches over
to normal operation.