Speakers; Removing The Speakers - Dell MF6F1 Service Manual

Steps
1. Using the alignment posts, place the right I/O-board in place on the palm-rest assembly.
2. Replace the two screws (M2x3) that secure the right I/O-board to the palm-rest asssembly.
3. Connect the speaker cable to the connector on the right I/O-board.
4. Using the alignment pins, connect the right I/O-board cable on the right I/O-board and the system board.
NOTE: The I/O-board cable is polarity sensitive. To prevent damage to your computer ensure that the MB UMT end of
the cable is connected to the system board.
5. Replace the two screws (M2x3) that secure the right I/O-board cable to the right I/O-board and system board.
6. Adhere the tape securing the coin-cell battery cable to the right I/O-board.
Next steps
1. Install the battery.
2. Install the 2230 solid-state
3. Install the 2280 solid-state
4. Install the base cover.
5. Follow the procedure in

Speakers

Removing the speakers

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the 2230 solid-state
4. Remove the 2280 solid-state
5. Remove the battery.
36
drive. (if applicable)
drive. (if applicable)
After working inside your
Before working inside your
drive. (if applicable)
drive. (if applicable)
computer.
computer.