Confirmation Of Assembly - Sega Let's Go Island Owner's Manual

6-7

CONFIRMATION OF ASSEMBLY

Use the TEST MODE to check whether or not the product has been correctly assembled and whether or not
everything operates normally.
• The seat moves during the initialization of the cabinet. Please wait and stand
aside of the cabinet during this time. Do not touch the seat while it is initializing.
6
1
Turn ON the power switch.
2
The Billboard and Rear Moulding LED's will illuminate along with the Plasma Disc.
3
The Gameboard logo is displayed on screen
4
The initialization screen appears on screen. Take precautions since the initialization operation will begin.
5
When the seat initialization is complete, the seat will move to it's set position and the advertising screen will
appear on screen.
6
Press the TEST button to enter the SYSTEM TEST MENU screen. (See Chapter 9)
7
MONITOR TEST screen
Select "MONITOR TEST" in SYSTEM TEST MODE to bring up the MONITOR TEST screen.
The monitor is shipped from the factory pre-adjusted but you may use the MONITOR TEST screen to
determine whether it need to be re-adjusted. If adjustment is needed, refer to the section of this manual
under the section MONITOR LCD.
8
Select the "GAME TEST MODE" in the SYSTEM TEST MODE.
9
The initialization screen will reappear, again take precaution as the seat initialization will begin.
10
INPUT TEST screen
Select "INPUT TEST" in the GAME TEST MODE to bring up the INPUT TEST screen, allowing you to
test the input devices to verify operation.
11
OUTPUT TEST screen
Select "OUTPUT TEST" in the GAME TEST MODE to bring up the OUTPUT TEST screen, allowing you
to test devices such as lamps and LED's
12
CONTROLLER ADJUSTMENT screen
Select "CONTROLLER ADJUSTMENT" in the GAME TEST MODE to bring up the CONTROLLER
ADJUSTMENT screen, allowing you to calibrate the controllers. Select CALIBRATION and follow the on-
screen instructions.
32