Seat Mechanism - Sega Let's Go Island Owner's Manual

13

SEAT MECHANISM

• This work should be performed by site maintenance personnel or other skilled
professionals. Work performed by non-technical personnel can cause a severe
accident such as electric shock.
13
• When working with the product, be sure to turn the power OFF. Working with the
power on may cause an electric shock or short circuit.
• Exercise due caution in performing soldering procedures. If a soldering iron is
handled carelessly it could cause a burn or start a fire.
• Proceed very carefully when heating thermal contraction tubes (heatshrink).
Careless heating of such tubes may can cause burns or fire.
• Be careful not to damage wires. Damaging wires may cause electric shock,
short circuit or present a risk of fire.
• Do not touch undesignated places. Handling or touching such places may
cause an electric shock, short circuit or crush hazard.
• Stand back from the cabinet when applying power after maintenance has been
completed. The seat will automatically undergo an initialization operation when
power is restored. failure to move away from the product could result in a crush,
pinch or fall hazard.
• Be careful not to get a hand or finger caught when removing or attaching parts
within the moving mechanism.
• Exercise extreme caution when handling the internal parts on the rear cabinet.
Pay special attention when examining the rear cabinet, inspect for damage,
loss of components or warping. The loss of just one component i.e screw, can
result in damage or lead to damage and faulty operation of the entire unit.
After replacing or adjusting the volume, always set the volume movement
values at the CABINET SETTING>SEAT MOTION TEST in TEST MODE.
78