Dismantling The Charging Station - Husqvarna Automower Technical Manual

5.1.3 Assembling the chassis and body
IMPORTANT INFORMATION
Before assembling the upper and lower parts
of the chassis: Make sure parts are clean and
that no cables will be pinched. Dirt or the like
can prevent the chassis from being sealed
correctly. An unsealed chassis lets in
moisture, which can result in faults on the
mower. Always apply new grease before the
chassis halves are joined together.
The chassis halves must be assembled
correctly in order to prevent water leakage:
The edges on the upper section must sit
correctly in the groove on the lower section.
Grass and dirt squeezed between the two
halves mean the mower will not be sealed.
1. Assemble the upper and lower chassis parts.
When it is necessary to wipe off the edges due to
dirt new grease, part number 535 14 12-01, must
be applied before the halves are assembled.
2. Screw together the upper and lower parts of the
chassis using the twelve screws. The screws
should be tightened crosswise.
3. Fit the microswitch on the stop button and replace
the brass clip holding the microswitch.
4. Screw the body to the chassis using the four
screws.
5. Fit the connector on the charging cable and refit
the rubber grommet on the charging cable
properly.

5.2 Dismantling the charging station

1. Remove the cable to the transformer from the
wall socket.
2. Remove the connector for the contact strip, the
connector for the charging plate and the
connector for the guide wire if fitted, from the
circuit card.
3. Unscrew the two screws, torx 20, holding the
front on the tower.
4. Lift off the front.
5. Repair instructions
3012-337
Automower from 103
™