Service Schedule - Husqvarna Automower Technical Manual

7. Maintenance and service
The charging station, transformer and low voltage
cable should be kept indoors during the winter if
possible. It is then important to remember to protect the
ends of the boundary wire from moisture by placing
them, for example, in a tin with anhydrous grease.

7.3 Service schedule

The table below contains a checklist of points and
actions to be taken when servicing the Automower.
When faults or a need of cleaning are discovered, this
must be rectified before the mower is used again.
Table 16: Service schedule
No. Check/Action
Carefully clean the lead-throughs in
1.
the body, primarily the charging
cable (535 13 73-01) to ensure that
the rubber seals fit correctly.
Check the bearings, bearing cage
2.
and hub in the skid plate
(535 07 59-01). Clean between the
skid plate and blade disc
(535 12 63-01) as well as between
the blade disc and the rubber
bellows (535 12 23-01).
Clean under the body: Inside and
3.
outside of the drive wheels
(535 13 60-02), around the front
wheel axles (535 12 56-01) and the
chassis.
Check the blades and screws.
4.
Check the front wheel bearings.
5.
Check the rubber bellows
6.
(535 12 23-01) on the cutting height
adjustment. The rubber bellows
must not be damaged.
7. Check the charging strips
(535 13 59-01) and contact strips
(535 13 74-01).
Check the movability and function
8.
of the collision sensors
(535 12 25-01, 535 09 14-01),
liftsensor (535 12 25-01,
544 14 15-01) and the front body
suspension (535 14 42-01).
130 Automower from
For
information,
see:
page 129
page 129
Operator's
manual for
Automower
page 129
page 129
page 105
page 37
™
Replaced parts