Replacing The Wheel Motor - Husqvarna Automower Technical Manual

5.18 Replacing the wheel motor

The wheel motors can be replaced without dismantling
the chassis.
1. Unscrew the wheel hub (one screw hex 5) on the
wheel where the wheel motor is to be replaced.
2. Lift off the wheels.
3. Unscrew the four screws holding the wheel
motor, torx 20.
4. Lift out the motor.
5. Carefully remove the cable from the motor.
NOTE!
Remove the cable by pulling the
connector.
6. Secure the cable on the new motor.
7. Fit the new motor.
NOTE!
The motor must be fitted so that the axle
runs through the top part of the hole.
IMPORTANT INFORMATION
Ensure that there is no dirt between the
motor and the chassis. Also make sure that
the seal is seated correctly.
8. Replace the wheel. Make sure they are fitted to
the right axle.
9. Replace the hub.
It is not necessary to apply new thread locking
fluid. The screws can be reused about
5 – 10 times.
10. Check that the wheel motor works.
5. Repair instructions
3012-451
Automower from 115
™