Quick Check - Husqvarna Automower Technical Manual

2.2 Quick check

When the main menu shows: Press and hold down the
number 0 for two seconds to access the Quick check
function.
Quick check is a display mode where you can quickly
receive information about the software, loop system,
sensors and battery. Press YES to switch between the
different display modes. Press Arrow back to exit the
quick check function.
The software display mode presents:
• Ver:
The version of the mower program consisting of
both the edition (2.32) and program type (2006
LIFT).
• B:
Control box version
• Date:
Date of issue
• Time:
Time of issue
The loop system display mode presents:
• Loop signal value (Af, F, N and S):
Af = The strength of the A-signal measured via
the front loop sensor on the mower. The value
should lie between approximately 70 and 320 to
ensure good functionality. The closer to the loop
the mower is, the higher the value. When the
Automower is directly over the loop the value is 0
and when the mower is outside of the loop the
value is negative.
When the Automower is in the test position, see
page 36, the value for the F-signal should be
above 300 and for the N-signal the value should
be above 100.
To ensure the functionality of the guide wire, the
S-signal value should be (-) 250 – 320 next to the
guide wire.
• Quality:
A-, S-, F- and N-signals can only be interpreted
when the value for Quality is 100%. When the
value is 99% or lower, the loop system does not
function correctly and with that, the displayed
values for A, S, F and N will not be correct.
• Restarts:
Within 5 – 10 seconds after the function starts, the
restart value stabilises. When the value continues
to change this indicates that the system is affected
by interference or is defective.
2. Special menu functions
Ver: 02.32 B:33
2006 LIFT
Jan 10 2006
Date:
14:09:25
Time:
Af: 250
320
F:
Quality:
Restarts:
Automower from
S: -250
N: 110
100%
0
23
™