Excella - G 2630/G 2670; Table 080-39: Service Mode Summary, G 2420/G 243X - Miele G 1 Series Technical Information

Technical Information
until the "Start/Stop" LED flashes.
5. Release the Start/Stop button.
6. If the "Start/Stop" LED does not light up, repeat the procedure.
Acknowledgement indicator:
The "Start/Stop" LED flashes slowly (1 flash per second).
Options:
Function
Software version ID check
Display and delete fault
memory
Component test
Operating hours check
LED test

Table 080-39: Service Mode Summary, G 2420/G 243x

4.3.9

Excella - G 2630/G 2670

Initial requirements:
1. Close the door (open for G 2670).
2. Switch off the appliance.
Accessing:
1. Press and hold the C (clear) button.
2. Switch on the appliance.
Programming
Do not press the Delay
Start button. The "Delay
Start" LED is not lit.
Press the Delay Start
button once. The "Delay
Start" LED flashes once
quickly intermittently.
Press the Start/Stop
button. Press it again to
display faults that may
have been saved. To
delete the fault memory,
press the Start/Stop
button again and hold for
4 s.
Press the Delay Start
button 2x. The "Delay
Start" LED flashes 2x
quickly intermittently.
Press the Start/Stop
button. Press it again to
activate the next
component.
Press the Delay Start
button 3x. The "Delay
Start" LED flashes 3x
quickly intermittently.
Press the Delay Start
button 4x. The "Delay
Start" LED flashes 4x
quickly intermittently.
Press the Start/Stop
button once.
216
G 1xxx/G 2xxx
Display
"Rinse" LED is out or flashes. The
display shows the software version
ID no. in consecutive digits
(e.g., -818).
The "Rinse" LED is off or flashes.
The display shows F and a fault
code number alternately (for a list of
fault codes, see Table 080-2). If the
fault memory is empty, F and 0 are
displayed alternately.
The display shows which
component is being tested. For
example, if drain pump M8 is being
tested, U and 3 are shown
alternately. For the test sequence
and background information about
individual components and their
activation, see Section 080-2.2.
The display shows the number
of operating hours as follows: If the
appliance has run for 74 hours, h, 7
and 4 are displayed alternately.
The display shows 6.1. All LEDs
light up.