Replacing The Belts For The Hydraulic Pump - Stiga Titan Series Workshop Manual

4.7.4 Replacing the belts for the
hydraulic pump
A profile belts
Replace the belts for the hydraulic pump
as follows:
1. Remove the rear engine cover. See
"2.2.1".
2. Remove the right engine cover. See
"2.2.1".
3. Remove the belt cover by slackening
off the screws A (3x) that hold the cov-
er in place. Use a 10 mm socket.
4. Unscrew the lower screw B and slide
up the tensioner device C to its max
position, then tighten the upper screw
D for the tensioner device to maintain
its new position.
5. Remove the pulley E by locking the
starter crown wheel using a flathead
screwdriver F at the same time as re-
leasing the shaft nut. Use a 19 mm
socket.
6. Remove the fuel filter. Use two 13 mm
spanners.
7. Pull off the pulley with the belts still on
in order to then remove the belts and
remove the pulley completely.
WORKSHOP MANUAL
TITAN
Chapter
4 - Hydraulic system
D
B
F
EDITION Page
2018 76
A
C
E