Stiga TURBO 8211-0208-08 User Manual
  1. Manuals
  2. Brands
  3. Stiga Manuals
  4. Lawn Mower
  5. TURBO 8211-0208-08
  6. User manual

Stiga TURBO 8211-0208-08 User Manual

Stiga lawn mower user manual
Hide thumbs

Advertisement

Table of Contents

D
DEUTSCH
T u r b o
8211-0208-08

Advertisement

Table of Contents
loading

Related Manuals for Stiga TURBO 8211-0208-08

Summary of Contents for Stiga TURBO 8211-0208-08

  • Page 1 DEUTSCH T u r b o 8211-0208-08...
  • Page 2 SVENSKA...
  • Page 3 FULL 8. Briggs & Stratton LS 45 10. Honda GCV 12. Briggs & Stratton ES 45 14. Honda GCV SVENSKA 9. Briggs & Stratton ES 45, XTE 50 FULL/MAX ADD/MIN 11. Briggs & Stratton LS 45 13. Briggs & Stratton XTE 50 0,15 l.
  • Page 4 21. Briggs & Stratton LS 45 23. Honda GCV SVENSKA 19. Vänster / Left 22. Briggs & Stratton ES 45, XTE 50 20. Höger / Right Briggs & Stratton : 0,76 mm 0,75 mm Honda: 0,7-0,8 mm...
  • Page 5 SVENSKA 40 Nm...
  • Page 6 SYMBOLS The following symbols are displayed on the ma- chine in order to remind you about the safety pre- cautions and attention necessary when using the machine. The symbols mean: Warning! Read the Instruction Book and Safety Manual before using the machine. Warning! Keep spectators away.

  • Page 7: Using The Mower

    3. Tighten the locking nuts to the lower part of the handle. When these are tightened, the height of the handle can be adjusted by tightening the screws B with the enclosed wrench (fig. 2). ENGINE BRAKE CABLE Fit the engine brake cable to the engine brake, (fig.

  • Page 8: Starting The Engine (Honda)

    Note that you should always remember that petrol is a perishable commodity. Never buy more petrol than you can use up 30 days. STARTING THE ENGINE (Briggs & Stratton) 1. Place the lawn mower on flat, firm ground. Do not start in high grass. 2.

  • Page 9: Maintenance

    SPEED (*) Do not touch the variator control when the motor is not operational. This can have an adverse effect on the variator's performance. Set a suitable speed by moving the variator lever into one of the 4 positions (fig. 16). The different positions have the following speeds: Position : approx.

  • Page 10: Sparking Plug

    Briggs & Stratton LS 45 (fig. 21): Carefully re- move the air cleaner so that no dirt falls down into the carburettor. Take out the foam-plastic filter and wash it in liquid detergent and water. Dry the filter. Pour a little oil on the filter and squeeze it in. Refit the air cleaner.

  • Page 11: Changing Blades

    3. When the clutch loop is pressed in approx. 2 cm (posi- tion 1) there should be some resistance when moving the mower backwards. With the clutch loop fully pressed in (position 2) it should not be possible to pull the mower backwards.

This manual is also suitable for:

Turbo

Table of Contents