Table of Contents
Advertisement
Flip back armrest release lever A MUST be in the unlocked
(horizontal) position when placing the flip back armrest into
the arm sockets.
7.18.1 Installing
1.
Visually inspect to ensure flip back armrest release lever A is in
the unlocked (horizontal) position.
2.
Slide the flip back armrest B into the arm sockets (front socket
C and rear socket D) on the seat frame E.
Install the quick-release pin F through the rear arm socket D
3.
and flip back armrest.
4.
Lock the flip back armrest by pressing the flip back armrest
release lever into the locked (vertical) position.
5.
Repeat STEPS 1-4 for the opposite flip back armrest.
7.18.2 Removing
Unlock the flip back armrest B by positioning the flip back
1.
armrest release lever A into the unlocked (horizontal) position.
Remove the quick-release pin F that secures the flip back
2.
armrest to the rear arm socket D.
3.
Pull up on the flip back armrest and remove the armrest from
the arm sockets (front socket C and rear socket D.
4.
Repeat STEPS 1-3 for the opposite flip back armrest, if necessary.
1143192-L-03
7.19 Footrest Height Adjustment
7.19.1 70°
1.
Remove any accessory from the footrest(s).
Lay the footrest on a flat surface to simplify this
procedure.
2.
Remove the footrest from the wheelchair. Refer to 7.7
Installing/Removing 70A°, page 35.
3.
Remove the mounting screw A, washers B and locknut C that
secure the lower footrest assembly D to the upper footrest
support E.
4.
Reposition the lower footrest to the desired height.
5.
Reinstall the mounting screw, washers and locknut that secure
the lower footrest to the footrest support and tighten securely.
6.
Repeat STEPS 1-5 for the opposite wheelchair footrest, if
necessary.
Setup Maintenance
43
Advertisement
Table of Contents
