Appendix B: How To Manually Set The Ip Address Of The Patton Sn4112 - Extron electronics DMP Plus Series Configuration Manual

DMP Plus Series C V / C V AT – Patton POTS
Appendix B: How to manually set the IP address of the Patton
Login
Accessing your SmartNode via the local console port (or via a Telnet session) causes the login screen to
display. Type the factory default login: administrator and leave the password empty. Press the Enter
key after the password prompt.
login:administrator
password: <Enter>
172.16.40.1>
After you have successfully logged in you are in the operator execution mode, indicated by > as
command line prompt. With the commands enable and configure you enter the configuration
mode.
172.16.40.1>enable
172.16.40.1#configure
172.16.40.1(cfg)#
Changing the IP address
Select the context IP mode to configure an IP interface.
172.16.40.1(cfg)#context ip router
172.16.40.1(ctx ip)[router]#
Now you can set your IP address and network mask for the interface eth0.
Within this example a class C network (192.168.1.0/24) is assumed. The IP address in this example
is set to 192.168.1.253 (you should set this to an unused IP address on your network).
172.16.40.1(ctx-ip)[router]#interface eth0
172.16.40.1(if-ip)[eth0]#ipaddress 192.168.1.253 255.255.255.0
2002-10-29T00:09:40 : LOGINFO
2002-10-29T00:09:40 : LOGINFO
192.168.1.253(if-ip)[eth0]#
Copy this modified configuration to your new start-up configuration. Upon the next start-up the
system will initialize itself using the modified configuration.
192.168.1.253 (if-ip)[eth0]#copy running-config startup-config
172.16.1.99(if-ip)[eth0]#
The SmartNode can now be connected with your network.
Revision Date:
10/16/2020
SN4112
: Link down on interface eth0.
: Link up on interface eth0.
Page 22 of 28