Introduction; Overview Of Setup; Features Supported; Features Not Supported - Extron electronics DMP Plus Series Configuration Manual

DMP Plus Series C V / C V AT – Patton POTS

1.0 Introduction

This document provides essential instructions for configuring the VoIP lines of DMP Plus Series,
C V and C V AT models, with the Patton SN 4110 Series FXO.
DMP Plus Relates to the following products:
• DMP 128 Plus C V / C V AT
• DMP 128 FlexPlus C V AT
• DMP 64 Plus C V / C V AT

1.1 Overview of setup

VoIP Line 1 in the DMP Plus will be directly connected to the LAN interface of the Patton POTS
interface. This does not need to be connected to a network.
call server or Patton POTS
The DMP Plus and Patton POTS interface need to be located on the same subnet / VLAN

Features supported

• POTS interface will support a single POTS line on FXO Port 0/0
• Hold is supported

1.1.1 Features not supported

• 3-Way calling is not supported
• Hook Flash is not supported
• VoIP Dialer in DSP Configurator Software will not work since the line does not
register to a call server.

1.1.2 DMP Plus setup

Figure 1 DMP 64 Plus C V AT – Rear
Figure 2 DMP 128 Plus C V AT - Rear
interface.
• Firmware: 1.06.0000 or Higher
• Line 1: Ext 1001
• LAN2 IP address: 192.168.1.254 / 255.255.255.0
• LAN2 port of the DMP Plus
LAN
2
Revision Date:
10/16/2020
The DMP Plus will not register to a
LAN
2
Page 5 of 28