Intermatic Grasslin talento smart B15 Operating Instructions Manual page 66

Any use other than the intended use is considered incorrect use. The legal warranty is voided by any inter-
ference with, or modifications to, the device.
Danger due to insufficient wire cross-section!
If wires with an insufficiently large cross-section are used, short circuits or fires may occur.
WARNING!
− Only use terminals with a cross-section between 1 mm² and 2.5 mm² for wires.
Damage to the DIN-rail timer due to incorrect installation location!
If installed in an unsuitable location, the DIN-rail timer may be damaged.
NOTE!
− Only use the DIN-rail timer in dry rooms and do not install close to devices with induc-
tive discharge (motors, transformers, etc.).
− Only install the DIN-rail timer on DIN rails.
Residual risks
The device is state-of-the art and designed in accordance with current safety requirements.
However, residual risks remain that require caution when using the device. The residual risks, and the
conduct and measures they require, are listed in the following.
FCC Certification
FCC ID: 2AHH/-DG
This device complies with Section 15 of the FCC Regulations. Operation is only permitted under the follow-
ing conditions: (1) This device must not cause any disruptive interferences and (2) the device must be able
to receive interferences, also such interferences which could result in undesired operations.
Electric current
Risk of fatal electric shock!
Improper assembly and installation of the device can lead to life-threatening electrical
WARNING!
voltages.
− Only allow a qualified electrician to install and connect the device.
EN
66