Mercedes-Benz GLE Operator's Manual page 216

214 Driving and parking
Off-road level +3: three indicator lamps
R
2 light up continuously when the vehicle
has finished rising.
Your selection is saved. The off-road level set
remains stored even after the ignition has been
switched off.
The vehicle is lowered again in the following sit‐
uations:
Off-road level +3: when driving faster than
R
12 mph (20 km/h) or when the rear fog lamp
is switched on.
The vehicle is lowered to off-road level +2.
Off-road level +2:
R
When driving faster than 50 mph
-
(80 km/h).
When driving briefly between 40 mph
-
(65 km/h) and 50 mph (80 km/h).
The vehicle is lowered to off-road level +1.
Off-road level +1:
R
When driving faster than 71 mph
-
(115 km/h).
When driving briefly between 62 mph
-
(100 km/h) and 71 mph (115 km/h).
The vehicle is lowered to the normal level.
After selecting a different drive program
R
using the DYNAMIC SELECT switch.
The vehicle is adjusted to the height of the
active drive program.
Lowering the vehicle (vehicles with Off-road
package)
Pull rocker switch 1.
#
Off-road level +3: the vehicle is lowered
R
to off-road level +2. Two indicator lamps
2 light up continuously when the vehicle
has finished lowering.
Off-road level +2: the vehicle is lowered
R
to off-road level +1. One indicator lamp
2 lights up continuously when the vehi‐
cle has finished lowering.
Off-road level +1: the vehicle is lowered
R
to the normal level. No indicator lamp
lights up when the vehicle has finished
lowering.
Your selection is saved. The off-road level set
remains stored even after the ignition has been
switched off.
Operation with a trailer or bicycle rack
If the electrical connection to the trailer or bicy‐
cle rack is established correctly:
Up to approximately 12 mph (20 km/h): off-
R
road levels +1, +2 and +3 can be selected
regardless of the drive program.
Up to approximately 19 mph (30 km/h): off-
R
road levels +1 and +2 can be selected
regardless of the drive program.
From approximately 19 mph (30 km/h): the
R
vehicle is set to the normal level regardless
of the drive program.
Setting the entering/exiting level (AIRMATIC)
Requirements:
The engine is running.
R
The vehicle is moving at speeds less than
R
20 mph (30 km/h).
2