Mercedes-Benz GLE Operator's Manual page 130

128 Light and visibility
High beam
To switch on: turn the light switch to the
#
L or à position.
Push the combination switch in the direction
#
of arrow 1.
When the high beam is activated, the L
indicator lamp for low beam is deactivated
and replaced by the K indicator lamp for
high beam.
To switch off: push the combination switch
#
in the direction of arrow 1 or pull it in the
direction of arrow 3.
High-beam flasher
Pull the combination switch in the direction
#
of arrow 3.
Turn signal light
To indicate briefly: push the combination
#
switch briefly to the point of resistance in the
direction of arrow 2 or 4.
The corresponding turn signal light will flash
three times.
To indicate permanently: push the combi‐
#
nation switch beyond the point of resistance
in the direction of arrow 2 or 4.
Vehicles with Active Lane Change Assist:
Indicator operation activated by the driver
R
can extend for the duration of the lane
change.
If the driver indicated directly beforehand
R
but a lane change was not immediately
possible, the turn signal indicator may
activate automatically.
Activating/deactivating the hazard warning
lights
Press button 1.
#
The hazard warning lights will switch on auto‐
matically if:
The airbag has been deployed.
R
When the indicator is activated, the hazard warn‐
ing lights are interrupted.