Mercedes-Benz GLE Operator's Manual page 162

160 Driving and parking
Fording
Also observe the following information when
fording:
Drive no faster than 6 mph (10 km/h).
R
Observe the maximum permissible fording
R
depth ( page 383).
/
Switch off automatic climate control
R
( page 144).
/
Ensure that a bow wave does not form as you
R
drive.
Do not stop in the water and do not switch
R
off the engine. Ensure the ECO start/stop
function is switched off ( page 162).
/
Driving in mountainous terrain
Also observe the following information when
driving in mountainous terrain:
Observe the values of the approach/depar‐
R
ture angle and of the maximum gradient
( page 383).
/
Avoid high engine speeds.
R
Use the braking power of the engine when
R
driving downhill.
Shift to a lower gear on uphill gradients and
R
on long, steep downhill gradients.
Activate DSR before driving downhill, if nec‐
R
essary ( page 194).
/
Checklist after driving off-road
Driving off-road places greater demands on your
vehicle than driving on normal roads. Check the
entire vehicle for damage and foreign bodies
every time after driving off-road. Foreign bodies
in the wheels or drivetrain can lead to imbalan‐
ces and therefore vibrations.
If the F or G drive program is selec‐
R
ted: select another drive program.
Deactivate DSR.
R
Lower the vehicle level again to a level suita‐
R
ble to the road conditions, e.g. to the normal
level.
Apply the brakes to dry them after fording.
R
Check that the service brake is working nor‐
R
mally after a long downhill stretch.
Clean the following components every time
R
after driving off-road:
license plate number
-
headlamps and tail lamps
-
tires, wheels and wheel arches
-
underbody
-
After driving through sand, mud, water or
R
gravel, have the following components
checked and cleaned:
brake discs and brakepads
-
tires and wheels
-
axle joints
-
ECO start/stop function
Operation of the ECO start/stop function
Mercedes-AMG vehicles: observe the notes in
the Supplement. You could otherwise fail to rec‐
ognize dangers.
% The ECO start/stop function is available only
in the C, A, ;, N and =
drive programs (depending on the setting).