Mercedes-Benz GLE Operator's Manual page 179

Press and hold button 1, 2 or
#
wish to program.
Indicator lamp 4 flashes yellow.
% It can take up to 20 seconds before the indi‐
cator lamp flashes yellow.
Release the previously pressed button.
#
Indicator lamp 4 continues to flash yellow.
Point remote control 5 from a distance of
#
0.4 in (1 cm) to 3 in (8 cm) towards button
1, 2 or 3.
Press and hold button 6 of remote control
#
5 until one of the following signals appears:
Indicator lamp 4 lights up green contin‐
R
uously. Programming is complete.
Indicator lamp 4 flashes green. Pro‐
R
gramming was successful. Additionally,
synchronization of the rolling code with
the door system must also be carried out.
If indicator lamp 4 does not light up or flash
#
green: repeat the procedure.
Release all of the buttons.
#
3 that you % The remote control for the door drive is not
included in the scope of delivery of the
garage door opener.
Synchronizing the rolling code
Requirements:
The door system uses a rolling code.
R
The vehicle must be within range of the
R
garage door or door drive.
The vehicle as well as persons and objects
R
are located outside the range of movement
of the door.
Press the programming button on the door
#
drive unit.
Initiate the next step within approximately
30 seconds.
Press previously programmed button 1,
#
or 3 repeatedly until the door closes.
When the door closes, programming is com‐
pleted.
% Please also read the operating instructions
for the door drive.
Driving and parking 177
Troubleshooting when programming the
remote control
Check if the transmitter frequency of remote
#
control 5 is supported.
Replace the batteries in remote control 5.
#
Hold remote control 5 at various angles
#
from a distance of 0.4 in (1 cm) to 3 in
(8 cm) front of the inside rearview mirror.
You should test every position for at least
25 seconds before trying another position.
Hold remote control 5 at the same angles
#
at various distances in front of the inside
rearview mirror. You should test every posi‐
tion for at least 25 seconds before trying
another position.
Note that some remote controls transmit
#
only for a limited period, press button
2
remote control 5 again before transmission
ends.
Align the antenna line of the door opener unit
#
with the remote control.
6 on