Table of Contents
Advertisement
above-quoted regulation.
Gas Connection
The installation of the cooker to Natural Gas or LP Gas must be carried out by a qualified gas engineer. Installers shall
take due account of the provisions of the relevant British Standards Code of Practice, the Gas Safety Regulations and
the Building Standards (Scotland) (Consolidation) Regulations issued by the Scottish Development Department.
It is recommended that the gas connection to the cooker is installed with a flexible connecting tube
made to BS 5386.
Installation to Natural Gas
Installation to Natural Gas must conform to the Code of Practice, etc. The supply pressure for Natural Gas is 20 mbar.
Installation to Liquid Petroleum Gas
This appliance must only be connected to LPG after an LPG conversion kit has been fitted. The installation must
conform to the relevant British Standards.
Only a suitably qualified and registered person may convert the appliance to a different gas type.
• When using Butane gas a supply pressure of 28 - 30 mbar is required.
• When using Propane gas a supply pressure of 37 mbar is required.
• Flexible hoses can be used where the sited ambient temperature of the hose does not exceed
• Gas hoses designed for natural gas MUST NOT be used for supplying LPG gas (LPG gas hoses
• The hose should not be crushed or trapped or be in contact with sharp or abrasive edges. It
https://producthelp.fisherpaykel.com/eu/Cook/Freestanding_Cookers/Dual_Fuel/OR90LDBGFX3/User_Guide_OR90LDBGFX...
70°C. These hoses must be manufactured in accordance with BS669 part 1 and be of the
correct construction for the type of gas being used.
can be identified by a either a red band or stripe on the rubber outer coating of the hose).
should also not be subjected to corrosion by acidic cleansing agents.
Updated: Fri, 10 Apr 2020 07:18:41 GMT
Powered by
8
Advertisement
Table of Contents
