Grizzly EXTREME Series Owner's Manual page 23

Loosen the outfeed table lock and rotate the
5.
handwheel until the cutter edge just touches
the straightedge when at TDC, then tighten
the table lock.
The outfeed table MUST be even with the
cutter edges to reduce the risk of kickback
and to help ensure good cutting results.
Tip: Some advanced woodworkers have found
that they can virtually eliminate snipe by set-
ting the outfeed table in the following manner:
Perform Steps 1–5. Then lower the outfeed
table slightly so the knife or insert lifts the
straightedge off the table. Place a ruler next
to the straightedge and rotate the cutterhead,
watching how far the carbide insert pulls the
straightedge. Adjust the outfeed table and
recheck until the knife or insert moves the
straightedge only ⁄ ".
5
32
Extreme Series Jointer (Mfd. Since 10/20)
Loosen the jam nut and adjust the outfeed
6.
stop bolt underneath the table so that it just
touches the bottom of the tables, as shown in
Figure 25, then re-tighten the jam nut.
Note: When adjusted to the correct outfeed
table height, use the stop bolt for a conve-
nient method of ensuring the outfeed table is
set at the proper height.
Stop Bolt
Figure 25. Table stop bolt (viewed from
underneath the table).
Re-install the motor access cover, fence
7.
assembly, and cutterhead guard.
Jam Nut
-21-