Introduction; Manual Accuracy; Contact Info; Machine Description - Grizzly EXTREME Series Owner's Manual

Manual Accuracy

We are proud to provide a high-quality owner's
manual with your new machine!
We made every effort to be exact with the instruc-
tions, specifications, drawings, and photographs
in this manual. Sometimes we make mistakes, but
our policy of continuous improvement also means
that sometimes the machine you receive is
slightly different than shown in the manual.
If you find this to be the case, and the difference
between the manual and machine leaves you
confused or unsure about something, check our
website for an updated version. We post current
manuals and manual updates for free on our web-
site at www.grizzly.com.
Alternatively, you can call our Technical Support
for help. Before calling, make sure you write down
the Manufacture Date and Serial Number from
the machine ID label (see below). This information
is required for us to provide proper tech support,
and it helps us determine if updated documenta-
tion is available for your machine.
Manufacture Date
Serial Number
Extreme Series Jointer (Mfd. Since 10/20)

INTRODUCTION

Contact Info

We stand behind our machines! If you have ques-
tions or need help, contact us with the information
below. Before contacting, make sure you get the
serial number and manufacture date from the
machine ID label. This will help us help you faster.
Grizzly Technical Support
1815 W. Battlefield
Springfield, MO 65807
Phone: (570) 546-9663
Email: techsupport@grizzly.com
We want your feedback on this manual. What did
you like about it? Where could it be improved?
Please take a few minutes to give us feedback.
Grizzly Documentation Manager
P.O. Box 2069
Bellingham, WA 98227-2069
Email: manuals@grizzly.com

Machine Description

A jointer is used to flatten the face or edge of
a workpiece, which is required when properly
"squaring up" a workpiece for later construction
or jointing. A jointer can also cut bevels and other
specialized cuts with various jigs or fixtures.
A typical cut on a jointer is made by firmly holding
a workpiece against the infeed table and fence,
then moving the workpiece over the cutterhead
while using the fence as a guide. As the workpiece
moves over the cutterhead, the knives or cutters
make many shallow cuts that "shave" off the sur-
face of the workpiece. Since only a small amount
of the workpiece is removed during a jointer cut,
most jointer cuts are repeated many times to yield
a desired result.
-3-