Grizzly EXTREME Series Owner's Manual page 20

Installing Fence (G9860/G960ZX)
Remove the motor access panel on the back
1.
of the machine.
Remove the cap screws and lock wash-
2.
ers that are pre-installed on the bottom of
the fence support, then, with assistance,
secure the support to the jointer with these
cap screws and lock washers, as shown in
Figure 18.
Fence Support
Figure 18. Installing the fence support.
Align the keyway underneath the fence sup-
3.
port key (see Figure 19), then place the
fence assembly on top of the support.
Fence Support Key
Figure 19. Fence support key.
Slide the flat washer onto the fence lock
4.
shaft, insert the shaft into the hole on the top
of the fence assembly and through the slot of
the support.
-18-
To secure the fence assembly, thread the
5.
T-slot nut onto the bottom of the lock shaft so
that nut fits up into the slot of the fence sup-
port, as shown in Figure 20.
Fence Lock
Figure 20. Installing the fence lock.
Installing Fence (G9953ZX/G9953ZXF)
Remove the six pre-installed cap screws and
1.
lock washers on either side of the fence base
support (see Figure 21).
With assistance, place the fence assembly
2.
onto the fence base support.
Fence Mounting Cap
Screws (3 of 6)
Fence
Base
Support
Figure 21. Fence assembly installed.
Secure the fence assembly with the six cap
3.
screws and lock washers removed in Step 1.
Extreme Series Jointer (Mfd. Since 10/20)
T-Slot Nut
Fence Assembly