Engine Oil Life Reset - Dodge DURANGO 2021 Owner's Manual

Unstored Messages

This message type is displayed indefinitely or
until the condition that activated the message
is cleared. Examples of this message type are
"Turn Signal On" (if a turn signal is left on) and
"Lights On" (if driver leaves the vehicle with the
lights on).
Unstored Messages Until RUN

These messages deal primarily with the
Remote Start feature. This message type is
displayed until the ignition is in the RUN state.
Examples of this message type are "Remote
Start Canceled - Door Ajar" and "Press Brake
Pedal and Push Button to Start."
Five Second Unstored Messages

When the appropriate conditions occur, this
type of message takes control of the main
display area for five seconds and then returns
to the previous screen. An example of this
message type is "Automatic High Beams On."
E O L R
NGINE IL IFE ESET
Oil Change Required
Your vehicle is equipped with an engine oil
change indicator system. The "Oil Change
Required" message will display in the instrument
cluster display for five seconds after a single
chime has sounded, to indicate the next
scheduled oil change interval. The engine oil
change indicator system is duty cycle based,
which means the engine oil change interval may
fluctuate, dependent upon your personal driving
style.
Unless reset, this message will continue to
display each time the ignition is placed in the
ON/RUN position. To turn off the message
temporarily, push and release the OK or arrow
buttons. To reset the oil change indicator system
(after performing the scheduled maintenance),
refer to the following procedure.
GETTING TO KNOW YOUR INSTRUMENT PANEL
Vehicles Equipped With Keyless Enter 'n Go —
Ignition
Use the steering wheel instrument cluster
display controls for the following procedure(s):
1. Without pressing the brake pedal, push the
ENGINE START/STOP button and place the
ignition in the ON/RUN position (do not
start the engine).
2. Push and release the down
to scroll downward through the main menu
to "Vehicle Info."
3. Push and release the right
to access the "Oil Life" screen.
4. Push and hold the OK button to reset oil life.
If conditions are met, the gauge and numeric
display will update to show 100%. If conditions
are not met a pop-up message of "To reset oil
life engine must be off with ignition in run" will
be displayed (for five seconds), and the user will
remain at the Oil Life screen.
5. Push and release the up
arrow button to exit the submenu screen.
91
3
arrow button
arrow button
or down