Rain Sensing Wipers - If Equipped - Dodge DURANGO 2021 Owner's Manual

Windshield Washers
To use the washer, push on the end of the lever
(toward the steering wheel) and hold. If the lever is
pushed while in the intermittent setting, the wipers
will turn on and operate for several cycles after the
end of the lever is released, and then resume the
intermittent interval previously selected.
Windshield Washer Operation
If the end of the lever is pushed while the wipers
are in the off position, the wipers will operate for
several cycles, then turn off.
NOTE:
As a protective measure, the washer will stop if
the switch is held for more than 20 seconds.
Once the switch is released the washer will
resume normal operation.
WARNING!
Sudden loss of visibility through the
windshield could lead to a collision. You might
not see other vehicles or other obstacles.
To avoid sudden icing of the windshield
during freezing weather, warm the windshield
with the defroster before and during
windshield washer use.
Mist
Rotate the end of the lever downward to the
MIST position and release for a single wiping
cycle.
NOTE:
The Mist feature does not activate the washer
pump; therefore, no washer fluid will be sprayed
on the windshield. The wash function must be
used in order to spray the windshield with
washer fluid.
For information on wiper care and replacement,
see Ú page 302.
GETTING TO KNOW YOUR VEHICLE
R S W — I
AIN ENSING IPERS
This feature senses rain or snowfall on the
windshield and automatically activates the
wipers. Rotate the end of the multifunction
lever to one of four detent positions to activate
this feature.
The sensitivity of the system can be adjusted
with the multifunction lever. Wiper delay
position one is the least sensitive, and wiper
delay position four is the most sensitive.
Setting three is preferred by the average driver
during normal rain conditions.
NOTE:
The Rain Sensing feature will not operate

when the wiper switch is in the low or
high-speed position.
The Rain Sensing feature may not function

properly when ice, or dried salt water is
present on the windshield.
Use of Rain-X or products containing wax or sili-

cone may reduce Rain Sensing performance.
The Rain Sensing feature can be turned on and

off using the Uconnect system Ú page 175.
57
E
F QUIPPED
2