Chapter 15 Introducing The Smt; Connect To Your Zyair Using Telnet; Changing The System Password; Figure 104 Login Screen - ZyXEL Communications G-3000H User Manual

This chapter describes how to access the SMT and provides an overview of its menus

15.1 Connect to your ZyAIR Using Telnet

The following procedure details how to telnet into your ZyAIR.
1 In Windows, click Start (usually in the bottom left corner), Run and then type "telnet
192.168.1.2" (the default IP address) and click OK.
2 For your first login, enter the default password "1234". As you type the password, the
screen displays an asterisk "*" for each character you type.

Figure 104 Login Screen

3 After entering the password you will see the main menu.
Please note that if there is no activity for longer than five minutes (default timeout period)
after you log in, your ZyAIR will automatically log you out. You will then have to telnet into
the ZyAIR again. You can use the web configurator or the CI commands to change the
inactivity time out period.

15.2 Changing the System Password

Change the ZyAIR default password by following the steps shown next.
1 From the main menu, enter 23 to display Menu 23 – System Security.
2 Enter 1 to display Menu 23.1 – System Security – Change Password as shown next.
3 Type your existing system password in the Old Password field, and press [ENTER].

Chapter 15 Introducing the SMT

Introducing the SMT
Password : xxxx
C
H A P T E R
G-3000H User's Guide
1 5
.
159