Olympus OEP-5 Instructions Manual page 78

Irregularity
The print picture is blurred. The edge enhancement setup is incorrect.
The print picture looks
rough.
A line goes into a print
picture.
There is rattling sound
during printing.
No buzzer beep is
generated.
The remote control unit
(MAJ-898) cannot be used.
A print sheet jam occurred
7
Paper jamming happens
frequently.
78
7.1 Troubleshooting Guide
Possible cause
The thermal head has reached the end of its
service life.
There are only a few print sheets in the paper
tray.
The system setups are incorrect.
No batteries are loaded.
Batteries are exhausted.
When it is used as the wireless remote, there is
an obstacle between it and the remote sensor on
the instrument.
When it is used as the wireless remote, it is
used from out of the reach of the
communication signal.
When it is used as the wireless remote, its
remote transmitter is not pointed toward the
remote sensor on this instrument.
When the remote control unit (MAJ-898) is
used as a wireless remote, the remote cable is
connected to either the REMOTE 1 terminal of
this instrument or the cable connector of the
remote control unit (MAJ-898).
Take measures as described in "4.3 In the Case of a Paper Jam" in "INSTRUCTIONS (BASIC)."
Print sheets have stuck to each other and these
stuck print sheets are double-fed into this
instrument.
Solution
Adjust the edge enhancement as described in "Setting
"HD SHARPNESS"" on page 63 or "Setting "SD
SHARPNESS"" on page 67 in "INSTRUCTIONS
(ADVANCED)."
Contact Olympus. The thermal head can be exchanged.
This is normal for this product, and is not a malfunction.
Set properly as described in "Setting "BEEP"" on page
56 in "INSTRUCTIONS (ADVANCED)."
Load batteries as described in "2.13 Preparation of the
Remote Control Unit (MAJ-898) (Optional)" on page 29
in "INSTRUCTIONS (ADVANCED)."
Replace batteries as described in "2.13 Preparation of the
Remote Control Unit (MAJ-898) (Optional)" on page 29
in "INSTRUCTIONS (ADVANCED)."
Remove the obstacle.
Use it as a wired remote by referring to "2.13 Preparation
of the Remote Control Unit (MAJ-898) (Optional)" on
page 29 in "INSTRUCTIONS (ADVANCED)."
Control it closer to this instrument.
Point the remote transmitter on the top of the remote
control unit (MAJ-898) at the remote sensor of this
instrument.
Remove the remote cable from this instrument or the
remote control unit (MAJ-898).
Flip through the print sheets together with the protective
sheet before placing them in the paper tray, referring to
the instructions in "3.2 Installation of the Color Printing
Pack (UPC-55) in "INSTRUCTIONS (BASIC)."
If there is no protective sheet, place other paper, such as
copy paper, on the printing surface of the print sheets so
that dust will not be accumulated on the printing surface.