Olympus OEP-5 Instructions Manual page 75

Irregularity Possible cause
The buzzer keeps A trouble occurred inside this instrument.
sounding.
No image is displayed on The switches on the rear and/or front of the
the monitor. monitor are set improperly.
The connected equipment is set improperly.
This instrument is connected improperly.
The connection cable is broken.
The brightness of the monitor is set improperly. Set it properly as described in the instruction manual for
The monitor is turned OFF.
The connected equipment is turned OFF.
This instrument is turned OFF.
The menu is displayed.
The system setups are inappropriate.
The output signal setups are inappropriate.
The video equipment connected between this
instrument and the connected equipment is
turned OFF.
Desired color tone is not The connection cable is broken.
obtained.
The color tone setup for the monitor is not
properly configured.
The color tone setup is not properly configured. Set it properly as described in the section 5.4 "Setup of
The displayed image The connected equipment is set to the still
remains still. (freeze) image mode.
The memory image is displayed.
The displayed image is The cables are connected improperly.
unstable.
The connection cable is broken.
The sync signal is set improperly.
The displayed image A source of strong magnetic field is present
oscillates. near the monitor.
The printed picture is The connected equipment is set improperly.
blurred.
The subject is moving at a high speed.
Solution
Turn this instrument OFF, then ON again after a while.
Set the switches properly as described in the instruction
manuals for the monitor and other ancillary equipment.
Set the connected equipment properly as described in its
instruction manual.
Connect it properly as described in Chapter 2,
"Installation and Connection" in "INSTRUCTIONS
(BASIC)" or "INSTRUCTIONS (ADVANCED)."
Replace the cable with a new one.
the monitor.
Turn the monitor ON.
Turn the connected equipment ON.
Turn this instrument ON.
Press the "MENU" button to close the menu display.
Set the system properly as described in the description on
the "5.4 Setup of the "Color tone adjustment" Menu" on
page 54 or "5.8 Setup of the "COLOR BALANCE"
Menu" on page 59.
Set the system properly as described in the description on
the "5.4 Setup of the "Color tone adjustment" Menu" on
page 54 or "5.9 Setup of the "INPUT SETUP" Menu" on
page 60.
Turn the video equipment ON.
Replace the cable with a new one.
Set it properly as described in the instruction manual for
the monitor.
the "Color tone adjustment" Menu" on page 54.
Release it from the still (freeze) image mode to view the
moving image.
Press the "SOURCE/MEMORY" button to display the
source image (see page 42).
Connect it properly as described in "Chapter 2
Installation and Connection" in "INSTRUCTIONS
(BASIC)" or "Chapter 2 Installation and Connection" on
page 17 in "INSTRUCTIONS (ADVANCED)."
Connect it properly as described in "Chapter 2
Installation and Connection" in "INSTRUCTIONS
(BASIC)" or "Chapter 2 Installation and Connection" on
page 17 in "INSTRUCTIONS (ADVANCED)."
Set it properly as described in the description on the
"Setting "SD SYNC(IN)"" on page 61 in
"INSTRUCTIONS (ADVANCED)."
Install the monitor away from the source of strong
magnetic field.
Set it properly as described in "3.3 Setup of Connected
Equipment" in "INSTRUCTIONS (BASIC)" or "3.1
Setup of Connected Equipment" on page 32 in
"INSTRUCTIONS (ADVANCED)."
Freeze the image before capturing it.
7.1 Troubleshooting Guide
7
75