Olympus OEP-5 Instructions Manual page 77

Irregularity Possible cause
The number displayed on The communication problem has occurred
the "CVP counter" does not between this instrument and connected
increase even if an image equipment.
has been captured.
The connected equipment is set improperly.
The communication speed (BAUDRATE) is set
improperly.
The remote cable is connected improperly.
The remote cable is broken.
The remote cable is being subjected to
excessive force.
The endoscope or scope cable is connected
improperly.
Images cannot be printed. The video cable is connected improperly.
The video cable is broken.
The video cable is being subjected to excessive
force.
No image has been captured.
No ink ribbon is installed.
The ink ribbon is installed improperly.
This ink ribbon has been torn.
No print sheets are installed.
The print sheets are installed improperly.
"AUTO PRINT" is set to "OFF."
The input signal is switched.
The HDTV image with the The aspect ratio is incorrectly set.
16:9 aspect ratio is printed
improperly.
The color tones in the print Some setups are incorrect.
picture are incorrect.
Solution
Turn this instrument OFF, then ON again.
Turn the connected equipment OFF, then ON again.
Set the connected equipment properly as described in
"3.1 Setup of Connected Equipment" on page 32, or in
"3.3 Setup of Connected Equipment" in
"INSTRUCTIONS (BASIC)."
Set it properly as described in "Setting "BAUDRATE""
on page 56 and in the instruction manual for the
connected equipment.
Connect the remote cable properly as described in
"Chapter 2 Installation and Connection" on page 17 or in
"Chapter 2 Installation and Connection" in
"INSTRUCTION (BASIC)."
Replace the new remote cable.
Change the cable layout to remove the excessive force.
Connect the endoscope or scope cable properly as
described in the instruction manual for the connected
equipment.
Connect it properly as described in Chapter2,
"Installation and Connection" in "INSTRUCTIONS
(BASIC)" or "INSTRUCTIONS (ADVANCED)."
Replace the new video cable.
Change the cable layout to avoid any excessive force.
Capture an image.
Install the ink ribbon as described in "Installation of the
Ink Ribbon" in "3.2 Installation of the Color Printing
Pack (UPC-55)" in "INSTRUCTIONS (BASIC)."
Install the ink ribbon as described in "Installation of the
Ink Ribbon" in "3.2 Installation of the Color Printing
Pack (UPC-55)" in "INSTRUCTIONS (BASIC)."
Repair the tear as described in "If the ink ribbon is torn in
the middle" in "3.2 Installation of the Color Printing Pack
(UPC-55)" in "INSTRUCTIONS (BASIC)."
Install the print sheets as described in "Installation of the
Print Sheets" in "3.2 Installation of the Color Printing
Pack (UPC-55)" in "INSTRUCTIONS (BASIC)."
Install the print sheets as described in "Installation of the
Print Sheets" in "3.2 Installation of the Color Printing
Pack (UPC-55)" in "INSTRUCTIONS (BASIC)."
Set "AUTO PRINT" to "ON" or "ON&CLEAR,"
referring to "Setting "AUTO PRINT"" on page 64.
Perform printing manually from the front panel of this
instrument or by a remote operation from the connected
equipment.
Set the signal format of the switched input signal,
referring to "5.8 Setup of the "COLOR BALANCE"
Menu" on page 59.
Adjust the aspect ratio properly, referring to "Setting
"HD ASPECT"" in "5.11 Setup of the "HDTV SETUP"
Menu" on page 63 in "INSTRUCTIONS
(ADVANCED)."
Adjust the color tones as described in "5.10 Setup of the
"OUTPUT SETUP" Menu" on page 62 in
"INSTRUCTIONS (ADVANCED)."
7.1 Troubleshooting Guide
7
77