Siemens SINUMERIK 802C base line Technical Manual page 99

35110 GEAR_STEP_MAX_VELO
rev/min Maximum speed for gear change (gear stage no.): 0..5
_always 500,
2000, 4000, 8000
35120 GEAR_STEP_MIN_VELO
rev/min Minimum speed for gear change (gear stage no.): 0..5
_always 50, 50, 400, 800,
1500, 3000
35130 GEAR_STEP_MAX_VELO_LIMIT
rev/min Maximum speed of gear stage (gear stage no.): 0...5
_always 500, 500, 1000, 2000,
4000, 8000
35140 GEAR_STEP_MIN_VELO_LIMIT
rev/min Minimum speed of gearsetp (gear stage no.): 0...5
_always 5, 5,10, 20, 40, 80
35150 SPIND_DES_VELO_TOL
Factor Spindle speed tolerance
_always 0.1
35160 SPIND_EXTERN_VELO_LIMIT
rev/min Spindle speed limitation from PLC
_always 1000
35200 GEAR_STEP_SPEEDCTRL_ACCEL
rev/s^2 Acceleration in speed control mode [gear stage no.]: 0...5 NEW CONF
_always 30, 30, 25, 20, 15, 10 2
35210 GEAR_STEP_POSCTRL_ACCEL
rev/s^2 Acceleration in position control mode (gear stage no.):
1...5
_always 30, 30, 25, 20, 15, 10 2
35220 ACCEL_REDUCTION_SPEED_POINT
Factor Speed for reduced acceleration
_always 1.0
35230 ACCEL_REDUCTION_FACTOR
Factor Reduced acceleration
_always 0.0
35240 ACCEL_TYPE_DRIVE
– Type of acceleration
0
SINUMERIK 802C base line
Start-Up
500, 1000, 0.0
0.0
0.0
0.0
0.0
0.0
0.0
0.0
0
Technical Appendix
NEW CONF
plus DOUBLE 2/7
NEW CONF
plus DOUBLE 2/7
NEW CONF
plus DOUBLE 2/7
NEW CONF
plus DOUBLE 2/7
RESET
1.0 DOUBLE 2/7
NEW CONF
plus DOUBLE 2/7
*** DOUBLE 2/7
NEW CONF
*** DOUBLE 2/7
RESET
1.0 DOUBLE 2/7
RESET
0.95 DOUBLE 2/7
RESET
1 BOOLEAN 2/7
6-11