Siemens SINUMERIK 802C base line Technical Manual page 95

31030 LEADSCREW_PITCH
mm Pitch of leadscrew
_always 10.0
31040 ENC_IS_DIRECT
– Encoder mounted directly to the machine (encoder no:)
_always 0
31050 DRIVE_AX_RATIO_DENOM
– Denominator load gearbox (control parameter no.): 0...5
_always 1, 1, 1, 1, 1, 1
31060 DRIVE_AX_RATIO_NUMERA
– Numerator load gearbox (control parameter set no.): 0...5 POWER ON
_always 1, 1, 1, 1, 1, 1
31070 DRIVE_ENC_RATIO_DENOM
– Denominator resolver gearbox (encoder no.)
_always 1
31080 DRIVE_ENC_RATIO_NUMERA
– Numerator resolver gearbox (encoder no.)
_always 1
31090 JOG_INCR_WEIGHT
mm, Evaluation of an increment with INC/handwheel
degrees
32000 MAX_AX_VELO
mm/min, Maximum axis velocity
rev/min
_always 10000.
32010 JOG_VELO_RAPID
mm/min, Rapid treverse in jog mode
rev/min
_always 10000.
32020 JOG_VELO
mm/min, Jog axis velocity
rev/min
_always 2000.
32070 CORR_VELO
% Axis velocity for handwheel override, ext. ZO, cont.
dressing, distance control
_always 50
SINUMERIK 802C base line
Start-Up
0.0
***
1
1
1
1
0.0
0.0
0.0
0.0
Technical Appendix
POWER ON
plus DOUBLE
POWER ON
*** B O O LE A N 2/7
POWER ON
2147000000 DWORD
2147000000 DWORD
POWER ON
2147000000 DWORD
POWER ON
2147000000 DWORD
RESET
NEW CONF
plus DOUBLE
RESET
plus DOUBLE
RESET
plus DOUBLE
RESET
plus DWORD
2/7
2/7
2/7
2/7
2/7
2/7
2/7
2/7
2/7
6-7