System Commands - Ericsson RX8 Series Manual

Supported Alteia Protocol Commands and Messages
4.15

System Commands

Command = SYS
SUB
58 (59)
Description
Set alarm relay mask
SET (System 3000 format)
Read alarm relay mask
MSK
(System 3000 format)
Request system alarm
SRQ status
(System 3000 format)
Set alarm mask
SAM (Alteia Alarm format)
Read summary alarm mask
AAL (Alteia Alarm format)
Set alarm relay mask
RL1 (Alteia Alarm format)
Set alarm relay mask
RL2 (Alteia Alarm format)
Set alarm relay mask
RL3
(Alteia Alarm format)
Set alarm relay mask
RL4 (Alteia Alarm format)
Set alarm relay mask
RL5 (Alteia Alarm format)
Set alarm relay mask
RL6
(Alteia Alarm format)
Read alarm relay setting
ALR (Alteia Alarm format)
Request alarm status
SRA (Alteia Alarm format)
Set Control mode
CMO
SRS
Returns control mode
status
Set SI table acquisition
SIM
mode
SHM Set Service hunt mode
FET Set current front-end
SRB Set small rate buffer mode
enable
5VS Set 525 video start line
NNN Parameter Description
hhhh See notes below
None Returns the relay mask
Returns the alarm status
hhhhh See notes below
None Returns the alarm mask
hhhhh
hhhhh
hhhhh
hhhhh
hhhhh
hhhhh
- Returns the alarm relay mask
- Current alarm status
Command not supported
(Always active Remote Control mode )
LOM Locan control mode
RCM Remote control mode
OAM Over-air mode
SNM SNMP mode
Always return SRS;CMO=RCM_
-
DVB DVB SI
ATS ATSC SI
AUT Determine SI automatically
ENA Enable
DIS Disable
ASI Local ASI connector
OP1 Option slot 1
Command not supported
Command not supported
Document No. ST.TS.EXXXXX.1 2010-03-04