Ericsson RX8 Series Manual page 36

Supported Alteia Protocol Commands and Messages
System information bypass selection commands are used to control directly which
elementary streams are required. This bypasses the Service Guide and other Service
Information (SI) tables.
SUB
QUA
SRQ
QUA response:
\000:OPR;SIG=ddd_EBN=cdd.d_BER=ddE-d_$FFCr
where parameters are as given above, and the following additional parameters:
SUB
SIG
EBN
BER
SRQ response:
\000:OPR;SIG=ddd_ALR=hhhh_BER=ddE-d_ALL=hhhhh_SAQ=ccc_$FFCr
where parameters are as given above, and the following additional
SUB
SIG
ALL
BER
SAQ
NOTE...
The alarm bitmaps of the Alteia and System 3000 formats.
A bit set represents an alarm condition as follows
36 (59)
Description
Requests quality status
Requests operational
status
Description
Input signal strength
(satellite input)
C/N value
Error Ratio (satellite input)
(post Viterbi)
Description
Input signal strength
(satellite input)
Alarm status (Alteia type)
Error Ratio (satellite input)
(post Viterbi)
Signal acquisition mode
Alteia alarm bitmap
(16 bit)
Bit Mask Description
NNN Parameter Description
See below
See below
NNN Parameter Description
Signal strength in nominal
ddd units, range 000 to 255, where
255 represents full scale.
C/N value +/- range of 00.0 to
cdd.d 99.9
BER value in scientific format,
ddE-d range for mantissa is 10 to 99,
range for exponent is -1 to -8
NNN Parameter Description
Signal strength in nominal
units, range 000 to 255,
where 255 represents full
ddd scale.
hhhhh See Note
BER value in scientific format,
range for mantissa is 10 to 99,
range for exponent is -1 to -7
(Will return 1E-8 for decoder
ddE-d IRD)
ACO Actual only (always returned)
System 3000 alarm bitmap (20
Bit Mask
Document No. ST.TS.EXXXXX.1 2010-03-04
parameters:
bit)
Description