Transport Stream Output Commands - Ericsson RX8 Series Manual

Supported Alteia Protocol Commands and Messages
The SRQ response example:
\004:AU2;ROU=M2_LEV=M19_OUT=AC3_DFL=eng_LVL=POS00_ADM=PLS_
OPS=0_CLN=eng-eng-M_COD=LIN_DYN=RF_ERR=---_AUR=AES1AES2_$4D
where parameters are the same as for Audio 1.
4.12

Transport Stream Output Commands

Command = TSO
The transport stream output commands allow the configuration of the ASI output
connectors when they are configured for that mode. This section also covers the
configuration of said connectors between HD-SDI and TSO.
SUB
54 (59)
DYN Set dynamic range mode
ERR Set fail mode
AUR Select audio routing
SRQ
Request audio status
Description
CAM
Set TSO stream routing
Set TSO fibre output
ENA enable
SRQ Requests TSO status
Set connector 1
CON
configuration
CO2
Set connector 2
configuration
AAC AAC
HEAAC HE AAC
LIN Linear
DT1 DTS1
DT2 DTS2
DT3 DTS3
LO Line Out
RF RF mode
OFF Off
SIL
VBT Command not supported
MUT
AES1 AES1 routed to Audio Dec.1
AES2 AES2 routed to Audio Dec.1
AES3 AES3 routed to Audio Dec.1
AES4 AES4 routed to Audio Dec.1
NONE Audio Dec.1 is not routed.
- See below
NNN Parameter Description
PRE Encrypted output
(POST INPUT)
PST Unencrypted output
(POST ES DESCRAMBLE)
ENA
DIS Command not supported
See below
DIS Disabled
TSO ASI transport stream output
SDI SD-SDI output
HDI HD-SDI
ADI AUTO
DIS Disabled
TSO ASI transport stream output
Document No. ST.TS.EXXXXX.1 2010-03-04