Ericsson RX8 Series Manual page 23

SUB
FRQ
CHN
CHS
OFS
OFV
GDI
BER
SDM
OCM
SDV
DHS
INS
ERR
SRQ
ERR response: \000:DTV; PRE=d.ddE-d_POST=d.ddE-d_$FFCr, where
SUB
PRE
POST
Document No. ST.TS.EXXXXX.1 2010-03-04
Description
Frequency in kHz
Channel number
Channel spacing
Setting a tuner offset is not
supported
Setting a tuner offset is not
supported
Setting the guard interval in
DVB-T, note that "Tuning
mode" must be "Custom"
and "Use custom mode and
guard" must be checked.
Setting Post-Viterbi BER
alarm threshold
Setting signal degradation
mode is not supported
Set OFDM carrier mode in
DVB-T, note that "Tuning
mode" must be "Custom"
and "Use custom mode and
guard" must be checked.
Setting signal degradation
mode is not supported
Set hierarchy stream in
DVB-T. It sets the "Profile"
on RX8000. It is only
applied if "Tuning mode" is
set to "Custom".
set input selection between
baseband and UHF and
whether it is inverted or not.
Not supported.
reports Pre- and Post-
Viterbi errors
Reports the card status
Description
Detected pre-Viterbi error
(DVB-T)
Detected pre- LDPC error
(DVB-T2)
Detected post-Viterbi or
pre-RS error (DVB-T)
Detected pre- BCH error
Supported Alteia Protocol Commands and Messages
NNN Parameter Description
Note: a frequency beyond
the supported range will be
dddddd NAK-d
dd 5 or 6 to 12 in VHF,
21 to 69 in UHF
7
8
U "Unknown"
D "System's default"
POS
ZER
NEG
d
1/3 1/32
1/1 1/16
1/8
1/4
dE-d
OFF
ON
2
8
d
LP
HP
UHF Baseband is not supported,
BAS the spectrum inversion
IUH detection is done
IBA automatically
See below the response
- format
See below the response
- format
NNN Parameter Description
d.ddE-d
d.ddE-d
23 (59)