Audio Commands - Ericsson RX8 Series Manual

4.11

Audio Commands

4.11.1 Audio 1 Commands
Command = AUD
Audio commands allow the configuration of the Audio 1 sound circuits.
SUB
ROU
LEV
OUT
DFL
LVL
ADM
OPS
COD
DYN
ERR
AUR
SRQ
Document No. ST.TS.EXXXXX.1 2010-03-04
Description
Set audio output routing
Set audio Clipping level
Set output type
Not supported
Not supported
Set AC3 downmixing mode
Set output source
Set default audio standard
type
Set dynamic range mode
Set fail mode
Select audio routing
Request audio status
Supported Alteia Protocol Commands and Messages
NNN Parameter Description
ST Stereo
M1 Mono to left and right
M2 Mono L to left and right
M3 Mono R to left and right
Where dd is a decimal value
Mdd in range of 0-20 dB
PRO Professional AES/EBU
AC3 Consumer IEC958 AC3
OUT is supported only, if
4AUD license is enabled
Command not Supprted.
None Returns simly ACK.
Command not Supprted.
None Returns simly ACK.
CON Conventional stereo
PLS Pro logic stereo
ADM is supported only, if
4AUD license is enabled
None Command not supported
MUS Musicam
AC3 Dolby Digital AC-3
AAC AAC
HEAAC HE AAC
LIN Linear
DT1 DTS1
DT2 DTS2
DT3 DTS3
LO Line Out
RF RF mode
OFF Off
SIL
VBT Command not supported
MUT
AES1 AES1 routed to Audio Dec.1
AES2 AES2 routed to Audio Dec.1
AES3 AES3 routed to Audio Dec.1
AES4 AES4 routed to Audio Dec.1
NONE Audio Dec.1 is not routed.
- See below
47 (59)