Receive Timeouts; Data Transmission - Ericsson RX8 Series Manual

• Audio 3 commands (AU3)
• Audio 4 commands (AU4)
• Audio 5 commands (AU5)
• Audio 6 commands (AU6)
• Transport Stream output commands (TSO)
• NCP commands (NCP)
• Remote commands (REM)
• System commands (SYS)
• No PID Commands (NOP)
3.4

Receive Timeouts

No timeout is applied for the Alteia protocol; if the end of a message is lost, the
message parsing state machine will be reset when the next message start sequence is
detected and the old data automatically discarded.
3.5

Data Transmission

No mechanism is used to indicate when transmission is complete.
3.5.1 Half duplex mode
The protocol is command/response, so no further commands should occur until the
controller has received the previous reply. Attempts to send more data before the
previous transmission is complete will result in the new transmission request being
ignored.
3.5.2 Full duplex mode
Both the received messages and the reply messages of the executed commands are
queued. So it's allowed to occur further messages while the previous command
message is under procession.
No command messages will be ignored.
Document No. ST.TS.EXXXXX.1 2010-03-04
Supported Alteia Protocol Commands and Messages
15 (59)