Assigning A Function - Bosch PRAESENSA PRA-SCL Configuration Manual

PRAESENSA
Operation type
Abort phased announcement
Finish phased announcement
Make phased announcement
Toggle
Refer to
–
5.7.2

Assigning a function

The function determines which function is triggered if the control input or button becomes
active. The operation that can be assigned to a control input or button, depends on the
function. A function is always linked to an operation. See Assigning an operation, page 84 .
The available type of functions, and with which device functions are used, are represented in
the following tables:
Device
Call station
Call station extension
System controller
Multifunction power supply
Bosch Security Systems B.V.
Assigning a function, page 85
Description
operation is used for triggering events (for example, to
cancel a selection) and actions with a significant duration
(for example, an announcement).
The action is stopped when the external contact closes.
This type of operation is used for stopping actions that
were started with a Do once operation.
The action is stopped when the external contact closes.
This type of operation is used for stopping actions that
were started with a Do once operation.
The action coupled to a virtual control input of the
system controller is started/stopped/aborted depending
of the trigger by the Open Interface.
The action coupled to the button is started when the
contact closes and stopped when the contact closes
again.
Device abbreviation
(in next "Function" table)
CS
CSE
SC
MPS
Configuration manual
Configure the system | en
2020-09 | V1.20 | PRAESENSA 1.20
85