Structure As Of Byte X+8 For Diagnostic Interrupt (Analog Outputs) - Siemens SIMATIC ET 200M Manual

Commissioning and Diagnostics
Diagnostic Interrupt of Modules with Analog Outputs
Byte x+4
:
See Figure 6-11 on page 6-32
Byte x+7
Byte x+8
Byte x+9
Byte x+10
7 6 5 4 3
Byte x+11
Diagnostic event on channel/channel group 3 of the module
7 6 5 4 3
Byte x+12 0 0
Short-circuit to M
Wire break
External load voltage
Byte x+13: Assignment for channel/channel group 1 as for byte 12
Byte x+14: Assignment for channel/channel group 2 as for byte 12
Byte x+15: Assignment for channel/channel group 3 as for byte 12
Bytes x+16 to x+19: are always 00
Figure 6-15

Structure as of byte x+8 for diagnostic interrupt (analog outputs)

Process Interrupt of the IM 153-2
If the IM 153-2 reports a process interrupt, there is at least one data record
containing messages concerning time-stamped signal changes or special
messages.
The DP master CPU can read the data record(s) and evaluate them with
the 90 "IM_DRV" FB (see the PCS 7 documentation).
Evaluation with FB 62 "FB TIMESTMP" is also possible.
6-36
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
73 : Module with analog outputs
H
Length of the channel-specific diagnosis
Number of channels per module
2 1 0
Diagnostic event on the channel/channel group 0 of the module
Diagnostic event on the channel/channel group 1 of the module
:
2 1 0
Diagnostic events for channel/channel group 0
Configuration/parameter assignment error
Common-mode error
Short circuit to L+
H
Distributed I/O Device ET 200M
EWA-4NEB780600602-06