Siemens SIMATIC ET 200M Manual page 159

Maintenance
Putting a New Module into Service
Table 7-3 Putting new modules into service
Step
1. Open the front door.
2. Bring the front connector back into its operating position.
3. Close the front door.
4. Switch on the power supply for the IM 153-x.
5. Switch the load voltage back on.
Response of the ET 200M After Module Replacement
When you have replaced a module and no errors have occurred, the IM 153-x
starts data transfer. If the IM 153-x stays in STOP mode, you can display the
cause of the error with STEP 5 or STEP 7
7-10
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Putting a Module into Service
3
2
Distributed I/O Device ET 200M
EWA-4NEB780600602-06