Table of Contents
Advertisement
4.3 System
The System function allows viewing System information, IP Configuration, Password Setting and etc.
As shown in
Figure 4-3
and description on
The page includes the following information:
Object
System Information
IP Configuration
Password Setting
Firmware Upgrade
Configuration Setting
Configuration Backup
Managed IP
Fault Relay Alarm
Alert Trap Configuration
System Reboot
Table 4-3
Figure 4-3 System Screen
Display the MAC address, Software Version, Hardware Version, IP address, Subnet
Mask and Gateway.
Explained in section 4.3.1
Allow to change the IP subnet address of Switch.
Allow to change the username and password of Switch.
Allow proceed firmware upgrade process of Switch.
Allow to restore / backup configuration of Switch and reset Switch to factory default.
Explained in section 4.3.
Allow to download / upload the configuration file of Switch.
Allow to set the specific IP address to access the Web Smart Page.
section 4.3.7
Monitor the Power 1 and 2.
Set up SNMP trap receiver's IP address and trap event.
Allow reboot the Switch.
Table 4-3 Descriptions of the System Column
Description
Explained in section 4.3.8
Explained in section 4.3.10
-31 -
Explained in section 4.3.2
Explained in section 4.3.3
Explained in section 4.3.4
Explained in section 4.3.6
Explained in
Explained in section 4.3.9
User's Manual
Advertisement
Table of Contents
