Table of Contents
Advertisement
INTERRUPT
INTERRUPT can be used to temporarily stop a long copy run so that
a short job can be run.
Duplex copying, sort, group, staple sort, covers/inserts, and
transparency inserts cannot be selected during interrupt copying.
Also job program recall cannot be selected.
Reduction/enlargement/zoom, exposure adjustments, dual page
copying, erase, and margin shift can be selected during interrupt
copying.
When optional card counter (SF-EA11) is used and the copier has
been programmed in the audit account mode, INTERRUPT will
not function.
TRAY SELECT
3
6
9
CLEAR/STOP
C /
TRAY SELECT
Downloaded from:
http://www.usersmanualguide.com/
CLEAR ALL
CA
4
7
INTERRUPT
AUDIT
0 /
CLEAR
ERA
START
CHAN
CLEAR ALL
CA
4
7
INTERRUPT
AUDIT
0 /
CLEAR
I
I
Press the INTERRUPT key.
1
When the RADF is being used, the copier will stop after
completing the copying of the originals in progress.
If this copier has been programmed in the audit account mode,
the account number entry message will appear. Enter your
account number using the 10-key pad. The number of copies
and the cost of the interrupt copying will be accumulated
against this account number.
When the copier stops, remove the originals and set
2
the original for interrupt copying in the RADF tray or on
the document glass.
Select the desired available copier functions.
3
Press the START key.
4
When the interrupt copy run is complete, press the
5
INTERRUPT key again to cancel the mode and remove
the original used for interrupt copying.
The copier will reset itself to the functions which were in use
before the INTERRUPT key was first pressed.
Replace the originals for the interrupted job and press
6
the START key to resume copying.
47
Advertisement
Table of Contents
