Using The Radf - Sharp SD-2060 Operation Manual

USING THE RADF

The RADF (Reversing Automatic Document Feeder)
will handle A5 to A3 (8-1/2" x 5-1/2" to 11" x 17") size
originals.
Before loading originals into the RADF tray, be sure
to remove any staples or paper clips from them. The
RADF can handle a maximum of 50 originals.
Badly damaged originals may misfeed in the RADF.
It is recommended that these be copied from the
document glass and the copies be used as original
documents.
When feeding originals which have closely spaced
binding holes punched along an edge, place the
originals with the punched edge along the side
guides.
2
1
3
Downloaded from: http://www.usersmanualguide.com/
A4
h
A4
1.
B4
2.
TRAY SELECT
3. A3
I I
Special originals such as transparency film and
tracing paper should not be fed from the RADF, but
should be placed on the document glass.
Duplex copying will not work when a non-standard
size paper is used.
If 8-1/2" x 11"R (A4R) originals are set into the tray,
they will be sensed to be A4R (8-1/2" x 11"R).
Different size originals with the same width can be
placed on the RADF tray and automatically copied
onto their respective size copy paper.
The automatic copy ratio selection will not function
in this case.
When using B4, A3, or 8-1/2" x 14" (or 8-1/2" x 13"*) (8-1/2" x
14" or 11" x 17") size originals, unfold the auxiliary guide.
* Can be used in certain areas.
1-sided copies of 1-sided originals
Set the originals face down in the RADF tray and adjust
1
the original guides to the size of the originals.
If an original is left on the document glass, the Original
Reminder indicator will blink. Remove the original on the
document glass in this case.
The original size will be indicated in the message display, and
the paper tray with the corresponding paper size will be
selected.
If the required paper size is not installed in any of the trays, the
following message will appear.
<A0018>
LOAD -- PAPER.
To copy onto a different size paper, use the TRAY SELECT
key to make the selection.
11