Table of Contents
Advertisement
www.ti.com
1-2 (int): Power supply from JTAG interface
2-3 (ext): External power supply
Open to measure current
Orient Pin 1 of MSP430 device
Open to disconnect LED
LED connected to P1.0
Figure B-29. MSP-TS430QFN23x0 Target Socket Module, PCB
For bootloader use, the BSL connector and only one of the resistors R2 or R3 need to be populated. If
the board is supplied internally, R3 (0 Ω) must be assembled. If the board is supplied externally, R2 (0
Ω) must be assembled, and R3 must be removed.
SLAU278AG – MAY 2009 – REVISED DECEMBER 2020
Submit Document Feedback
Connector JTAG
For JTAG Tool
Jumper JP1
Jumper JP2
Jumper JP3
D1
Note
Copyright © 2020 Texas Instruments Incorporated
Hardware
Connector BOOTST
For Bootloader Tool
Connector J5
External power connector
Jumper JP1 to "ext"
MSP430™ Hardware Tools
73
Advertisement
Table of Contents
