Table of Contents
Advertisement
www.ti.com
1-2 (int): Power supply from JTAG interface
Jumpers JP5 to JP10
Close 1-2 to debug in Spy-Bi-Wire mode
Close 2-3 to debug in 4-wire JTAG mode
Orient Pin 1 of MSP430 device
LED connected to P1.0
Jumper JP2
Open to disconnect LED
Figure B-53. MSP-TS430RGC64B Target Socket Module, PCB
For bootloader use, the BSL connector and only one of the resistors R11 or R12 must be populated. If
the board is supplied internally, R11 (0 Ω) must be assembled. If the board is supplied externally, R12
(0 Ω) must be assembled, and R11 must be removed.
SLAU278AG – MAY 2009 – REVISED DECEMBER 2020
Submit Document Feedback
Jumper JP3
2-3 (ext): External
power supply
Connector JTAG
For JTAG Tool
D1
Copyright © 2020 Texas Instruments Incorporated
Jumper JP1
Open to measure current
Note
Connector BOOTST
For Bootloader Tool
Connector J5
External power connector
Jumper JP3 to "ext"
If the system should
be supplied from LDOI (J6),
close JP4 and set JP3 to "ext"
MSP430™ Hardware Tools
Hardware
111
Advertisement
Table of Contents
