Table of Contents
Advertisement
www.ti.com
Connector JTAG
For JTAG Tool
Jumper JP3
Open to measure current
CON12
External power connector
Jumper JP2 to "EXT"
Jumpers JP5, JP10
Open to disconnect LEDs
D2
LED (red) connected
to P3.6 through JP10
D1
LED (green) connected
to P1.0 through JP5
Crystal Q1
RF - 26 MHz
X1
RF - Signal SMA
The battery pack that is included with the EM430F5137RF900 kit may be connected to CON12. Ensure correct
battery insertion regarding the polarity as indicated in battery holder.
SLAU278AG – MAY 2009 – REVISED DECEMBER 2020
Submit Document Feedback
VCC
GND
GND
Figure B-89. EM430F5137RF900 Target board, PCB
Copyright © 2020 Texas Instruments Incorporated
Connector BOOTST
For Bootloader Tool
Jumper JP2
Close INT for power supply from JTAG interface
Close EXT to external power supply (CON12)
Jumper JP1
Close JTAG position to debug in 4-wire JTAG mode
Close SBW position to debug in Spy-Bi-Wire mode
Jumper JP1 in Spy-Bi-Wire mode
Push-button S2
Connected to P1.7
Q3
Footprint for 32-kHz crystal
R431 and R441
Use 0- resistor to make XIN and XOUT
W
available on connector Port 5
Button S1
Reset
Hardware
MSP430™ Hardware Tools
177
Advertisement
Table of Contents
